Product - Wastewater Treatment Solutions

Treatment for Tanneries

WATER TREATMENT FOR TANNERIES
Achieve up to 85% volume reduction in effluent by the Rochem® Membrane Technology Systems

FEATURES

Lower pre-treatment requirement
No Softening / Coagulation
No fine filtration and activated carbon filtration
No UF/NF pre-treatment
Ability to handle high COD/BOD loads negates the high fouling and scaling potential of tannery effluent
High recovery rates result in lower and manageable concentrated streams

CASE STUDY

Background: The effluent from the unit is being treated in the existing ETP. However, the ETP treated effluent was not meeting the discharge norms. The discharge needed to be treated further to achieve pollution norms

Plant installed: Rochem PF-RO System
(Microprocessor controlled, fully fail safe and unattended operation)

Input: 75 cum/day of treated waste water as input

Recovery Rate: 80%-85%

Plant Performance

Parameter	UNIT	Input to RO	RO Output
Flow	cum/day	50	43
TDS	ppm	< 8000	< 45
COD	ppm	< 2000	50
BOD	ppm	< 1000	< 30

Salient Features

The installed system treats the input waste water to a level of quality where it can be reused within the factory.
The concentrated reject from the plant is within manageable volume and easily treated through solar or other accelerated evaporation mechanisms available.

Product

Rochem Triple S/TS Module (NEW)

Round Shaped Membrane Cushions

Rochem PF Module

Rochem Module Technology

Rochem UF/MF/NF Module

Application

Industrial Waste Water

Landfill Leachate Treatment

Treatment for Distilleries

Treatment for Tanneries

Treatment for Pharmaceutical